The media could not be loaded.I had the intention to install these as extra turn signal and brake lights on the saddle bags on my 2019 Indian Roadmaster. I wired them to a Load Isolator so I do not have any issues with Canbus electrical system throwing any codes with these. I wired them up with some waterproof connectors I also got here on Amazon in the case the saddle bags have to be removed, there was a way to disconnect them without having to remove them.I put one on each side of the saddle bag, and one at the rear on each saddle bag. The turn signal function will overpower the brake function. If you test them and try to squeeze the brake it may flash red briefly inbetween the amber turn signal flashing, but the turn signal has priority. I also tested these with the flashers. When wired properly to your system, they will flash with your turn signals on the flasher function as well as directional functions. And then come on with the brakes are applied. They are not daily running lights. Just brake light (red), or turn signal (amber) function only.Fit and finish seems pretty good and really expected for the price point. I didn’t notice any obvious areas or issues with something that may not be waterproof as these are exposed to the elements. The brightness I saw left more to be desired from other reviewers. Daytime visibility in direct sunlight may be very hard to see. I don’t use these as primary turn signals. But for the brake and turn signal, a little more brightness for me anyways, is desired. May have to address that in the future, but for now, I will see how they last. I figured I’d give the benefit of a 5 star rating, but maybe would say 4.5 because they aren’t quite so bright.The wires are very thin on these. Probably at least a 24 gauge wire. So be very careful stripping them. If you strip the exterior black sheath that goes around all the wires, just be gentle and slow so you don’t inadvertently strip or cut any of the interior wires. It is probably possible to use your fingernail and fingertip to strip these thin wires back, to wire them up to something. I was able to use some waterproof heat shrinkable butt connectors to wire them in to the 5 pin waterproof connectors I got for these.